BMW 2009 M3 Sedan Manuale Proprietario
Opening and closing
36
for approx. 1 minute as long as no door has
been opened.
been opened.
Pinch protection system
If the glass roof encounters an obstruction dur-
ing closing from approximately the middle of
the opening in the roof, or during closing from
the raised position, the closing movement is
interrupted and the glass roof is opened again
slightly.
ing closing from approximately the middle of
the opening in the roof, or during closing from
the raised position, the closing movement is
interrupted and the glass roof is opened again
slightly.
Despite the pinch protection system
check and clear the roof's travel path prior
check and clear the roof's travel path prior
to closing it, otherwise the safety system might
fail to detect certain kinds of obstructions, such
as very thin objects, and the roof would con-
tinue closing.
fail to detect certain kinds of obstructions, such
as very thin objects, and the roof would con-
tinue closing.
<
Closing without pinch protection
If there is an external danger, press the switch
forward past the resistance point. The roof
closes without pinch protection.
forward past the resistance point. The roof
closes without pinch protection.
Following interruptions in electrical
power supply
After a power failure, there is a possibility that
the glass roof can only be raised. The system
must be initialized. BMW recommends having
this work done by your BMW center.
the glass roof can only be raised. The system
must be initialized. BMW recommends having
this work done by your BMW center.
Closing manually*
In the event of an electrical malfunction, you can
move the glass roof manually:
move the glass roof manually:
1.
Unclip the front of the cover of the interior
lamps using the screwdriver from the
onboard tool kit, refer to page
lamps using the screwdriver from the
onboard tool kit, refer to page
2.
Insert the screwdriver into the openings on
each side to press the clips.
each side to press the clips.
3.
Remove the control unit.
4.
Unplug the motor. Considerably less effort
will be required for manual operation.
will be required for manual operation.
5.
Insert the Allen wrench
*
supplied with the
onboard tool kit, refer to page
, into the
opening provided. Move the glass roof in
the desired direction.
the desired direction.
6.
Reinstall the control unit and reattach the
lamp cover.
lamp cover.
ba8_E90M3_cic.book Seite 36 Dienstag, 19. August 2008 11:51 11
Online Edition for Part no. 01 41 2 600 934 - © 08/08 BMW AG