BMW 2004 325i Sedan Manuale Proprietario
134
Coolant
Do not add coolant to the cooling
system when the engine is hot. If
system when the engine is hot. If
you attempt to do so, escaping coolant
can cause burns.
Antifreeze and anti-corrosion agents
are hazardous to health. You should
always store them in closed original
containers and in a location which is
out of reach of children. Antifreeze and
anti-corrosion agents are inflammable.
For this reason, do not spill them on hot
engine parts. They could ignite and
cause serious burns. Comply with the
instructions on the containers.
can cause burns.
Antifreeze and anti-corrosion agents
are hazardous to health. You should
always store them in closed original
containers and in a location which is
out of reach of children. Antifreeze and
anti-corrosion agents are inflammable.
For this reason, do not spill them on hot
engine parts. They could ignite and
cause serious burns. Comply with the
instructions on the containers.
<
Comply with the applicable envi-
ronmental laws regulating the dis-
ronmental laws regulating the dis-
posal of antifreeze agents with corro-
sion inhibitor.
sion inhibitor.
<
Checking the coolant level and
adding coolant
adding coolant
Check the coolant level when the
engine is cold, approx. 68
engine is cold, approx. 68
7/+206.
1. Open the cap for the expansion tank
by turning it slightly counterclock-
wise to allow accumulated pressure
to escape, then open
wise to allow accumulated pressure
to escape, then open
2. The coolant level is correct when the
upper end of the red float is at least
even with the upper edge of the filler
neck; see arrow. The end of the float
may stick out by a maximum of
3/4 in / 2 cm – that is, up to the sec-
ond mark on the float
even with the upper edge of the filler
neck; see arrow. The end of the float
may stick out by a maximum of
3/4 in / 2 cm – that is, up to the sec-
ond mark on the float
3. If necessary, add coolant. If the cool-
ant is low, slowly add coolant until
the correct level is reached – do not
overfill.
the correct level is reached – do not
overfill.
Brake fluid
Indicator lamp
The brake warning lamp comes
on when the parking brake is
not engaged: the brake fluid
on when the parking brake is
not engaged: the brake fluid
.
Brake warning lamp for Cana-
dian models.
dian models.
Adding brake fluid
For adding brake fluid or for determin-
ing and correcting the cause of brake
fluid loss, consult your BMW center.
Your BMW center is familiar with the
specifications for factory-approved
brake fluids – DOT 4.
ing and correcting the cause of brake
fluid loss, consult your BMW center.
Your BMW center is familiar with the
specifications for factory-approved
brake fluids – DOT 4.
Online Edition for Part-No. 01 41 0 157 602 - © 09/03 BMW AG