Buffalo Technology Buffalo AirStation Turbo G High Power WLI-TX4-G54HP Manuale Utente

If your Wireless Router/Access Point supports AOSS, then AOSS can 

configure your wireless network for you.  To use AOSS to connect your 

Ethernet converter to your wireless network:

•

  

Confirm that the Wireless Router/Access Point and the Ethernet 

Converter are both powered on.

•

 

Hold down the AOSS button on the Wireless Router/Access Point for 3 

seconds. 

•

 

Hold down the AOSS button on the Ethernet converter for 3 seconds.

AOSS will take about a minute to 

configure your wireless network.  When 

finished, the AOSS LEDs on both the 

Wireless Router/Access Point and the 

Ethernet Converter will stop blinking 

and stay lit.  You now have a secure 

connection!

NOTES:  If AOSS is used, then any non-AOSS wireless client devices in 

your network will have to be manually re-configured to connect to the 

Router/Access Point in AOSS mode; please consult your Router/Access 

Point documentation for more information on adding non-AOSS devices.
AOSS configures your SSID, encryption type, wireless channel, 

and encryption key, and makes a secure connection between 

your wireless components.  You may need to run your router's 

configuration utility to configure your internet connection before 

using AOSS.
If AOSS does not finish properly, power cycle both the Router/Access 

Point and the Ethernet Converter and attempt the AOSS process 

again.  AOSS works best when the router and the Ethernet Converter 

are physically close.  You can always move them further apart when 

configuration is complete.

AOSS button