BMW 330CI Manuale Utente

113

3. Hold the original control device

approx. 2 to 8 in / 5 to 20 cm away
from memory buttons 1.

The required distance between
the control device and the mem-

ory buttons 1 may vary, depending on
the system of the original control device
in question.

4. Simultaneously press the command

button of the original control device
and the desired memory button 1 on
the integrated universal remote con-
trol. Indicator lamp 2 starts to flash
slowly. When indicator lamp 2
flashes rapidly, release both but-
tons. If the indicator lamp 2 does not
flash rapidly after approx.
15 seconds, select a different dis-
tance between the two devices

5. To program other original control

devices, repeat steps 3 and 4.

The corresponding memory button 1 is
now programmed with the signal of the
original control device.

The system can be operated from igni-
tion key position 2.

If the system cannot be operated
after repeated attempts at pro-

gramming, check whether the original
control device is equipped with an
alternating-code system. You can either
check the operating instructions of the
original control device for this informa-
tion, or you can press and hold down
the programmed memory button 1 of
the integrated universal remote control.
If indicator lamp 2 of the integrated uni-
versal remote control flashes rapidly for
a brief period and then remains on for
approx. 2 seconds, the original control
device is equipped with an alternating-
code system. In this case, you have to
program the memory buttons 1 as
described below for an alternating-
code control device.

Programming an alternating-code
control device

You will need to follow the operating
instructions of the system in question in
order to program the integrated univer-
sal remote control. Read through the
operating instructions for information

on synchronization. Comply with the
following additional instructions when
you program an alternating-code con-
trol device:

You will find programming easier if
you have the assistance of

another person.

1. Park the vehicle within range of the

radio remote controlled device

2. Program the integrated universal

remote control as described above in
the section on fixed-code program-
ming

3. Locate the button on the receiver of

the target device, for example on the
drive

4. Press the button on the receiver of

the target device. Once you have
completed step 4, you have approx.
30 seconds to complete step 5

5. Press the programmed memory

button 1 of the integrated universal
remote control three times.

The corresponding memory button 1 is
now programmed with the signal of the
original control device.

Please contact your BMW center
if you have any questions.

Integrated universal remote control*

Overview

Controls

Maintenance

Repairs

Data

Index