Bostitch D61ADCSB Manuale Utente

-2-

SAFETY INSTRUCTIONS

EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which could
cause severe eye injury.

The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.

CAUTION: Additional Safety Protection will be required in some environments. For
example, the working area may include exposure to noise level which can lead to hearing
damage. The employer and user must ensure that any necessary hearing protection is
provided and used by the operator and others in the work area. Some environments will
require the use of head protection equipment. When required, the employer and user must
ensure that head protection conforming to ANSI Z89.1 is used.

Your D61ADCSB Side Strike Stapler is

shipped from factory completely assembled

and ready for use. Before operation, read the

provided Operation and Maintenance Manual

for the D61ADC Carton Closer, which is a part

of this machine. Follow the Operation and Air

Supply instructions carefully – note all the

Warnings and Cautions.
Please also note that the instructions in the

D61ADC manual for loading the magazine do

not apply in this case. The coil of staples are to

be mounted on the short piece of plastic tube

cradled above the tool. All other instructions in

the D61ADC manual apply.
After extensive use of the D61ADCSB, or

when exchanging the D61ADC staples, it may

be necessary to adjust either the trip foot or

the trip cylinder.

To prevent accidental

cycling, always disconnect the air supply
before making adjustments, servicing the
machine, clearing jams and when the
machine is not in use.

1. To Adjust the Trip Foot:

Disconnect the air supply. Loosen the two Trip

Foot mounting holes. The Trip Foot may be

moved on its slotted holes. Adjust so that the

Trip foot comes up flush against the bottom of

the D61ADC when the Valve is fully actuated.

The Trip foot and the Valve should bottom out

together.

2. To Adjust the Air Cylinder:

Make sure air supply is disconnected. With the

D61ADC Trigger held closed, there should be

a minimum clearance between the Trigger and

the Actuating Rod when the Rod is pushed

toward the Trigger to the end of the

Air

Cylinder stroke. Adjust the clearance by

loosening the two nuts that hold the

Air

Cylinder in the frame, and repositioning the Air

Cylinder and retightening the nuts. If the

Cylinder is being replaced, adjust the

Air

Cylinder in the frame.

Note: For best performance, the Depth
Adjustment on the D61ADC should be at a
high setting. At too low of an adjustment,
the driver will push the box away from the
D61ADCSB. The Front Adjustment Plate
of the D61ADC should be set at
approximately the number 3 setting; see
“Depth Adjustment” paragraph in the
D61ADC manual.

To prevent accidental

injury, never place hands or any other part
of the body in contact with the actuating
arm or in the staple clinching area.

Lubrication:

The D61ADCSB Side Strike Stapler should not

require lubrication other than the application of

a light machine oil to the pivot points two to

three times a year.
Refer to the Operation and Maintenance

Manual for the D61ADC for proper lubrication

of the tool.