Biostar TPower N750 Manuale Proprietario
Motherboard Manual
22
PEX16-1
PEX16-2
Notice: Make sure both the graphics cards are seated into slots
completely.
Step 5: Connect a 4-pin ATX power cable to PEX power connector
(PCIEX12V_CON1), this will ensure the stabilization of your system.
(PCIEX12V_CON1), this will ensure the stabilization of your system.
Step 6: Insert the SLI Bridge connector on the gold-fingers on each graphics
card.
card.
Front view Side view
Step 7: To securely fix the connector between two graphics cards, a retention
bracket must be installed.
Step 7-1: Remove any of the bracket cover between the two graphics
cards.
Step 7-2: Align and insert the retention bracket into the slot and then fix it
cards.
Step 7-2: Align and insert the retention bracket into the slot and then fix it
with a screw.
Notice:
1. Make sure the retention bracket supports the SLI Bridge firmly.
2. Retention bracket is optional
1. Make sure the retention bracket supports the SLI Bridge firmly.
2. Retention bracket is optional
Gold-fingers on two
graphic cards
graphic cards
Notice:
When under SLI mode, please make sure the
power supply is at least 500W or above.
When under SLI mode, please make sure the
power supply is at least 500W or above.