Belkin MIMO F5D9630-4A Dépliant

Quick Installation Guide

F5D9630-4A

User Manual CD
ADSL Modem with Wireless G+ MIMO Router
Power Adapter
RJ45 Ethernet Networking Cable
RJ11 Telephone Cord

Advanced Users: Go to the “Manually Confi guring your Router” 
section in your User Manual.

This Quick Installation Guide will lead you through the basic steps 
to connect and confi gure your Router.

IMPORTANT:  Please make sure you have the following information 

from your Internet Service Provider (ISP) before 
setting up the Router: For PPPoE and PPPoA Users: 
VPI/VCI numbers, user name, and password. For Fixed 
IP Users: IP address and subnet, IP address for your 
ISP’s gateway server and DNS.

Connect the Router to your computer and ADSL line

1.1

   Power off  your computers and networking equipment.

1.2 

  Connect your computer to one of the 

 “connections to 

your computers” ports on the rear of the Router by using an 
Ethernet networking cable.

 

DSL Line 

Ethernet Ports (4-1) 

Reset Button  Power Plug

1.3 

  Connect the telephone cord from the wall jack providing ADSL 

service to the 

  Connection for the Router to the ADSL line varies by country and 

region. Typically it involves a microfi lter or a microfi lter with built-in 
splitter to allow simultaneous use of ADSL service and telephone 
service on the same telephone line. Check with your ISP or see your 
User Manual for more detail.

1.4 

  Connect the supplied power adapter to 

 ”power plug” on 

the rear of the Router.

  For optimal safety and performance, use only the supplied power 

adapter to prevent damage to the Router.

1.5 

  After connecting the power adapter and the power source 

is turned on, the Router’s power icon 

 on the front panel 

should be on. It might take a few minutes for the Router to 
fully start up.

1.6 

  Turn on your computers. After your computers boot up, a LAN 

status LED 

 on the front of the Router will light for each 

port to which a wired computer is connecte d. These LEDs 
indicate connection and activity status. Now you are ready to 
confi gure the Router for ADSL connection.

Configure the Router

2.1

   In order for your computer to properly communicate with the 

Router, your computer’s network “TCP/IP/Ethernet” setting 
needs to be “Obtain an IP address automatically/ Using DHCP”. 
This is normally the default setting in most home computers. 
Detailed instruction on how to confi gure your computer 
network settings is available in your User Manual.

2.2

   You can access the web-based management user interface 

of the Router using the Internet browser on a computer 
physically connected to the Router. Type “192.168.2.1” in your 
browser’s address bar (as shown), then press the “Enter” key.

2.3

   The following screen will appear in your browser to prompt 

you to log in. The Router ships with no password entered. 
In the login screen, leave the password blank and click the 
“Submit” button to log in.

  It is strongly recommended that you change the password to your 

own for increased security. Please read the User Manual for details 
on how to change your password and to reference other security 
features.

Power 
LED

LAN Status 
LED (1-4)

Wireless LAN 
(WLAN) 
Status LED

ADSL 
LED

Internet 
LED