Behringer V-AMPIRE LX210 Manuale Utente

V-AMPIRE LX1200H/LX210

2. CONTROL ELEMENTS

The TAP button has seven functions:

Tap: Tap the rhythm of a piece of music on the TAP

button and the selected effect automatically adapts to the

tempo of the music.

Presence: While holding down the TAP button, you

can use the TREBLE control to change the PRESENCE

setting of the amp model youve selected.

parameter: You also can access the second effects

parameter set by using the EFFECT control while holding

down the TAP button.

Amp Models 17 - 32: Keep the TAP button pressed

down and select an amp model using the AMPS control.

MIDI Thru: The MIDI OUT connector can be set to act as

MIDI THRU (see

A).

Drive: Using the TAP button and the EFFECT control

changes the sound of the Wah-Wah effect.

Input Gain: By pressing the TAP button in the

configuration menu (see

) you change the value (please

refer to chapter 3.1 for further information).

Fig. 2.2: V-AMPIRE display

The DISPLAY shows you which preset bank you have

selected and gives you information on parameter changes

when you are editing. In TUNER mode the DISPLAY shows

the pitch of the instrument connected to the unit. If one of

the amplifier simulations 17 - 32 has been selected, the

LED in the bottom left-hand corner of the DISPLAY lights

up. Applied signals are indicated by the green SIGNAL

LED, overload signals by the red CLIP LED.
This control is for selecting an effect or a combination of

effects. This encoder-type rotary control is also surrounded

by a ring of 16 LEDs. Each LED corresponds to one specific

effects preset.
If an effect has been selected via

, its part of the

overall sound can be set using this EFFECTS control. If

you select the Compressor effect, you can use the

EFFECTS control to adjust the compression intensity.

Turning the control to the left until all the LEDs are off

disables the effect. This is known as an effects bypass.

By pressing the TAP button, you can set a second

effects parameter using the EFFECTS control

(see table

6.1

Using the REVERB control, you can gradually add reverb

to your overall sound. By turning it to the left until all the

LEDs are off, you deactivate the reverb. To fade out the

original signal, turn the control to the right until only the last

LED lights up.

The MASTER control determines the overall volume of

your device.

This is the only conventional non-programmable

control. All other controls are encoder-type rotary

controls whose settings can be stored as a preset.
The INPUT socket is the 1/4" connector for your guitar.

Please use a standard 1/4" TS connector.
The stereo PHONES connector allows you to monitor the

audio signal with standard headphone (e.g. BEHRINGER

HP series).

Your V-AMPIRE automatically activates studio mode

1 (S1) when connecting headphones. In this mode

the digital speaker simulations are activated. With

the headphones plugged in, you are able to select

any other configuration, e.g. for monitoring

purposes (see also chapter 3).

If you did not choose a speaker simulation with the

current setting and connect headphones, the device

will automatically switch to a speaker simulation.

This will increase the listeners sound impression.

Please refer to table 5.2 for detailed information on

the various speaker/amp combinations. However,

you can intentionally change or deactivate the

simulation when using headphones by selecting

- in the CABINETS mode (see

C).

WARNING!

Please note that high volume levels may cause

permanent damage to your hearing and/or your

headphones. Turn all LEVEL controls to the left

before you switch on the unit. Be sure to keep the

volume at an appropriate level.