Behringer DJ Equipment SX3242FX Manuale Utente

EURODESK SX2442FX/SX3242FX User Manual

behringer.com

Using this auxiliary mono output you can route the main mix signal to a separate 

power amp. The tunable low-pass filter allows you to limit the signal content to 

the low-frequency range to get a perfect subwoofer signal. This signal is mono 

because very low frequencies disperse quickly, so there would be no benefit to 

position this signal in the stereo mix.

Fig. 2.11: Mono out fader and low-pass filter

The 

[29]

MONO fader controls the volume of the signal present at the  

MONO OUT (see 

(32)

).

The 

[30]

FREQ control adjusts the cut-off frequency of the low-pass filter  

(30 to 200 Hz). Frequencies above cut-off are filtered out when activated.
Use the 

[31]

LOW PASS FILTER switch to activate the filter function (LED illuminates).

fig. 2.12: Mono out connector

The 

[32]

MONO OUT connector provides the line-level mono signal for 

connection to the inputs of a power amp or active speaker. You can also use 

this output as a monitor bus, e.g. to connect a headphone amplifier. In this 

case, the signal should of course not be limited by the low-pass filter.

Fig. 2.13: Main out fader

Use this high-precision 

[33]

MAIN fader to control the output level of the main mix.

Fig. 2.14: XLR main out connectors

The 

[34]

MAIN OUT(puts) are balanced XLR connectors with a nominal operating 

level of +4 dBu and provide the main mix signal.

Fig. 2.15: Main out connectors and main insert

The 

[35]

MAIN OUT ¼" TRS connectors outputs also provide the main mix signal.

Like the channel inserts, the 

[36]

MAIN INSERT connectors can be used to 

connect a dynamics processor or equalizer for further processing of the mix 

signal. The MAIN INSERT refers to the Main Outs (XLR and ¼" TRS 

connectors), the MONO OUT (see 

(32)

) and, if the MAIN switch in the 

PHONES/CONTROL ROOM section is pressed, also to the PHONES/CTRL ROOM 

output (see 

(46)

).

Fig. 2.16: Level meter

The red “

[37]

+48 V” LED illuminates when phantom power is on. 

Phantom power is required for the operation of condenser microphones, 

and can be switched on with the corresponding switch on the rear of 

the console.
The 

[38]

POWER LED is illuminated when the console is switched on.

The high-precision level meter accurately indicates the output signal level. 

[39]

For example, when you press the SOLO switch on one of the input channels, 

its signal level will be displayed here, either pre-fader (PFL) or post-fader 

(SOLO), depending on the position of the SOLO/ PFL switch (see 

(40)

). In PFL 

mode only the left display is active, because the PFL signals are mono.