Brother Z-8550A Manuale Proprietario

 

 

Z-8550A, 8560A 

70

 

The standard height of the presser foot (1) is 6 mm when 
the presser foot (1) is raised by means of the lifting lever (2). 

1. Loosen the two screws (3) and then remove the thread 

take-up guard (4). 

2.  Loosen the nut (5) of the presser adjusting screw (6), and 

then turn the presser adjusting screw (6) so that there is 
no pressure applied to the presser foot. 

3.  Raise the presser foot (1) by using the lifting lever (2). 
4. Loosen the screw (7) and move the presser bar (8) up 

and down to adjust the height of the presser foot (1) to 6 
mm. 

5.  Tighten the screw (7). 
6. Adjust the presser foot pressure using the presser 

adjusting screw (6), and then tighten the nut (5). 

7. Install the thread take-up guard (4) with the two screws 

(3). 

 
 
 
 
 
 
 
 
 

The standard height of the feed dog (1) when it is raised as 
far as possible above the surface of the needle plate is as 
given below. 

<8550A> 1 

mm 

<8560A> 

At the front 

1.1 mm 

 

At the back 

0.9 mm 

 

 

 

 

1. Turn the machine pulley to move the feed dog (1) to its 

highest position above the needle plate. 

2.  Tilt back the machine head. 
3.  Loosen the screw (2). 
4. Turn the pin (3) to move the feed bar (4) up and down in 

order to adjust the height. 

5.  Tighten the screw (2). 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Highest position 

Lowest position

3803M

3516M

3804M