Brother Z-8550A Manuale Proprietario

 

 

Z-8550A, 8560A 

73 

With the accessory needle bar height gauge (2) installed to 
the needle bar (1), adjust so that the needle bar height 
gauge (2) is touching the top of the needle plate (3) when 
the needle bar (1) is at its lowest position. 

1.  Remove the needle (4) and the presser foot (5). 

For the 8560A (Refer to Fig. A) 
1)  Remove the needle plate (3) and then the auxiliary 

needle plate (6). 

2)  Remove the needle plate spacer (7). 
3)  Place the needle plate (3) onto the needle plate 

installation surface. 

2. Install the accessory needle bar height gauge (2) to the 

needle bar (1), and then tighten it with the set screw (8). 

3.  Loosen the screw (9). 
4. Move the needle bar up or down to adjust so that the 

needle bar height gauge (2) is touching the top of the 
needle plate (3) when the machine pulley is turned so 
that the needle bar (1) is at its lowest position. 

5.  Securely tighten the screw (9). 
6.  Remove the needle bar height gauge (2). 
7.  For the 8560A, install the needle plate spacer (7), needle 

plate (3) and auxiliary needle plate (6). 

8.  Install the presser foot (5) and the needle (4). 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 

Touching 

8560A (Fig. A) 

3522M

3805M

Touching