Bravo View OVR-090BL Manuale Utente
INSTALLATION
PROFESSIONAL INSTALLATION RECOMMENDED!
Step B: (Wiring and Final Installation)
With
the
Metal
Bracket
securely
placed,
drill
a
small
hole
to
accommodate
the
wiring
cable
so
that
the “Din Cable”, male end is at the area where the monitor will be installed. Ideally, the hole for the
cable should be drilled in the middle of the mounting bracket. The other end of the cable should run
to the area in which you will have your source unit installed (ex. DVD Player).
Connect your SOURCE UNIT to one of the 2 sets of RCA cables (Yellow-‐Video Signal, Red Audio).
The Red fused wire should be attached to the “Accessory” wire of the vehicle. You can usually
find the “Accessory” lead at the fuse box. Take a voltage meter and test for +12 volt positive
power when the “Accessory” position of the key is turned on at the ignition switch. ALWAYS ENSURE
THAT YOUR ACCESSORY WIRE IS FUSED AT THE SOURCE! Attach the Black wire to any metal part of
the vehicle that is ground.
the “Din Cable”, male end is at the area where the monitor will be installed. Ideally, the hole for the
cable should be drilled in the middle of the mounting bracket. The other end of the cable should run
to the area in which you will have your source unit installed (ex. DVD Player).
Connect your SOURCE UNIT to one of the 2 sets of RCA cables (Yellow-‐Video Signal, Red Audio).
The Red fused wire should be attached to the “Accessory” wire of the vehicle. You can usually
find the “Accessory” lead at the fuse box. Take a voltage meter and test for +12 volt positive
power when the “Accessory” position of the key is turned on at the ignition switch. ALWAYS ENSURE
THAT YOUR ACCESSORY WIRE IS FUSED AT THE SOURCE! Attach the Black wire to any metal part of
the vehicle that is ground.
Step C: (Mounting)
With
the
vehicle
powered
off,
mount
the
monitor
into
place
using
the
pre-‐drilled
holes
(Prior
to
installation, always check the clearance of the screw lengths to ensure that you do not puncture the
roof).
installation, always check the clearance of the screw lengths to ensure that you do not puncture the
roof).
NOTE:
For
Wireless
Headphones
to
work
properly,
the
White
&
Red
RCA
output
must
be
connected
to
your
MOBILE
VIDEO
SYSTEM.