Bosch 3540 Manuale Utente
15.
maintenance
For your own safety, turn switch “OFF” and
remove plug from power source outlet be -
remove plug from power source outlet be -
fore maintaining or lubricating your saw.
The cord and the tool should be wiped with a dry clean
cloth to prevent deterioration from oil and grease.
cloth to prevent deterioration from oil and grease.
Certain cleaning agents and solvents can
damage plastic parts. Some of these are:
damage plastic parts. Some of these are:
gasoline, carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents which contain
am monia. Avoiding use of these and other types of cleaning
agents will minimize the possibility of damage.
solvents, ammonia and household detergents which contain
am monia. Avoiding use of these and other types of cleaning
agents will minimize the possibility of damage.
A coat of automobile-type wax applied to the table will help
to keep the surface clean and allow workpieces to slide
more freely.
to keep the surface clean and allow workpieces to slide
more freely.
If the power cord is worn or cut, or damaged in any way,
have it replaced immediately.
have it replaced immediately.
All repairs, electrical or mechanical, should
be attempted only by trained repairmen.
be attempted only by trained repairmen.
Contact the nearest Factory Service Center or Authorized
Service Station or other competent repair service. Use only
identical replacement parts, any other may create a hazard.
Service Station or other competent repair service. Use only
identical replacement parts, any other may create a hazard.
accessories
Use only recommended accessories. Follow
instructions that accompany accessories.
instructions that accompany accessories.
Use of improper accessories may cause hazards.
maintaining Your Tile Saw
WARNING
!
WARNING
!
WARNING
!
WARNING
!
Troubleshooting
Turn switch “off” and always remove plug from the power source before trouble shooting.
TRoUBle
pRoBlem
RemeDY
will not start
Power cord is not plugged in.
Plug in.
Fuse or circuit breaker tripped.
Replace fuse or reset tripped circuit breaker.
Cord damaged.
Have cord replaced by an Authorized Skil Service Center
or Service Station.
or Service Station.
Burned out switch.
Have switch replaced by an Authorized Skil Service Center
or Service Station.
or Service Station.
Does not come
up to speed
Extension cord too light or too long.
Replace with adequate cord.
Low house voltage.
Contact your electric company.
excessive vibration
Tile blade out of balance.
Discard tile blade and use different one, see page 11.
Tile blade bolt not tight.
See “Tile Blade Installation”, page 11.
WARNING
!
SM_2610008271_12-09:tile saw 12/17/09 3:25 PM Page 15