Whirlpool Washer W10254447B Manuale Utente

Proper installation is your responsibility. 

n

A water heater set to 120° F (49° C).

n

A grounded electrical outlet located within 6 ft (1.8 m) of 

power  cord on back of washer.

n

Hot and cold water faucets located within 4 ft (1.2 m) of hot  

and cold water fill valves on washer, and water pressure of  

20-100 psi (137.9-689.6 kPa).

n

A level floor with maximum slope of 1" (25 mm) under entire 

washer. Installing on carpet or surfaces with foam backing is  

not recommended.

n

Floor must support washer’s total weight (with water and load)   

of 315 lbs (143 kgs).

IMPORTANT: Do not install, store or operate washer where  

it will be exposed to weather or in temperatures below 32° F  

(0° C). Water remaining in washer after use may cause damage  

in low temperatures. See “Washer Care” in Washer Use and Care 

Guide for winterizing information.

All dimensions show recommended spacing allowed, except for 

closet door ventilation openings which are the minimum required.
For each arrangement, consider allowing more space for ease of 

installation and servicing, and spacing for companion appliances 

and clearances for walls, doors, and floor moldings. 
Space must be large enough to allow door to fully open.  

Add spacing of 1" (25 mm) on all sides of washer to reduce  

noise transfer. If a closet door or louvered door is installed, top 

and bottom air openings in door are required. 

/