Revox Recontrol M207 Manuale Utente

1.  Turn on the targeted device for the Re:control M207 to setting the 

device. 

2.  The Re:control M207 will directly get throw the setup mode when 

you operate the Re:control M207 at first time. Please tap the 

target device key in the Main Menu to enter “Setup device” menu. 

(ex. “TV” device) 

 

 

 

 

 

 

 

 

 

* Pre-code: load pre-programmed IR code from the factory 

default (no guarantee being able to control all brand 

devices). 

3.  Pressing the 

 or 

  buttons to choose “Yes” item and 

press 

  button for entering the operation mode. 

4.  Choose the first letter of targeted device brand (ex. n “S” on 

behalf of Sony, Samsung…etc ), and point the Re:control 
M207 at the targeted device, and then tap 

  o soft button 

to start auto searching. 

5.  As you see the targeted device has been turned off, please tap 

or press any buttons to stop auto searching right away. Tap 

 or 

  p gently to figure out the correct remote code 

(Code number as shown on the top middle position of the 

LCD.) till the targeted device has been turned on again. Press 
the power key or the hard key to test the codes to confirm the 

code. If the codes aren’t correct please continue repeat step 

4-5 again to search the proper code for your target device. 

6.  Finally, press 

  button to load the code and exit.