PS Audio Juice Bar Manuale Utente

Pagina di 4
3
use  a  PS  Audio  xStream  Power  cable.  To 
provide  the  best  electrical  connection  the 
Juice Bar should be plugged into a PS Audio 
Power Port duplex outlet. 
Confirm  that  the  blue  indicator  light  is  on. 
This light indicates the presence of live AC 
power. If the blue indicator light is not illumi-
nating then there is no power present. Verify 
the  power  source  is  active  or  the  power 
source is operational and providing power.
If  the  blue  LED  is  lit,  the  connected  equip-
ment is ready to use.
Wall  or  ceiling  mounting  instructions 
(Optional)
Two  #8  or  #10  screws  are  required.  Make 
sure the mounting surface is strong enough 
to  support  the  weight  of  the  Juice  Bar  and 
connected  power  cables,  i.e.,  wood  or  ply-
wood,  etc.  Alternatively,  wall  anchors  can 
be  used  if  the  surface  is  not  supportive 
enough.
Hold the unit in the desired mounting posi-
tion. Mark the location of the screws with a 
pencil. Pre-drill the holes at that location. 
Insert the screws through the holes at each 
end of the Juice Bar. While holding the Juice 
Bar in place tighten the screws until they are 
snug. Do not overtighten the screws.
Protection Features
Since  The  Juice  Bar  is  designed  for  maxi-
mum  performance  and  unrestricted  current 
flow it does not provide any protection as a 
lightning arrestor, surge suppressor or spike 
protector. 
To  properly  protect  connected  equipment, 
plug  the  Juice  Bar  into  a  product  that  pro-
vides  these  features  such  as  a  PS  Audio 
Power  Plant,  Ultimate  Outlet  or  any  other 
similarly designed device. This will not only 
extend  the  number  of  available  outlets  but 
extend the protection and cleansing benefits 
as well.
If the Juice Bar is not plugged into a device 
with  these  features  the  connected  equip-
ment is will not be protected. 
Specifications
Height 
 
- 1.75 in
Width 
 
- 2.75 in
Length 
 
- 16.25 in
Weight 
 
- 3 lbs
Internal wiring  
- 14 ga
Power inlet  
- 15 amp IEC
Warranty and Service
Inside the U.S. and Canada
PS  Audio’s  warranty  is  3  years  parts  and 
labor,  from  the  date  of  original  purchase. 
The  warranty  follows  the  product  itself 
regardless of ownership, new or used. 
Outside the U.S. and Canada
PS  Audio  has  authorized  distribution  in 
many  countries  of  the  world.  In  each 
country, the authorized importing retailer or 
distributor  has  accepted  the  responsibility 
for warranty of products sold by that retailer 
or  distributor.  Warranty  service  should 
normally  be  obtained  from  the  importing 
retailer  or  distributor  from  whom  you 
purchased the product. In the unlikely event 
of  service  required  beyond  the  capability 
of  the  importer,  PS  Audio  will  fulfill  the 
conditions  of  the  warranty.  Such  product 
must be returned at the owner’s expense to 
the PS Audio factory. Contact your PS Audio 
distributor or the PS Audio customer service 
department for more information. 
Service issues
Should  your  unit  ever  require  service  or  if 
you have any technical questions about the 
Juice  Bar,  ether  contact  your  dealer  (PS 
Audio if purchased direct) or your PS Audio 
distributor. No equipment will be received at 
our service facilities without an attached RA 
number. 
If  purchased  through  an  authorized  PS 
Audio  dealer  or  distributor,  the  RA  number 
must be obtained by the dealer or distributor. 
If  the  product  was  purchased  from  PS 
Audio direct, this can easily be obtained by 
contacting PS Audio at:
E-mail - service@psaudio.com
Phone - 720.406.8946
Fax - 720.406.8967