Namco Bandai Games Welder 90500019 Manuale Utente

Page

25

1)

Remove the rear cover (L).

2)

Remove the Pozi head screw (M4x10), and remove the earth terminal.
(

Note:

Be careful not to lose the internal washer (M4).

3)

Disconnect the two connectors on the EMI board, the AC fan connector,
and the four connectors on the I/O PCB.

4)

Remove the two Pozi head screws (M5x12), then remove the shield case.

1)

Pull out the shield case until the I/O board can be seen.
(Refer to section 6-3-3, above, "Removing the Shield Case".)

2)

Remove the four Pozi head screws (M3x20).
(

Note:

Be careful not to lose the four nylon spacers.

3)

Remove the I/O PCB.