MiTAC 7521 PLUS/N Manuale Utente
122
7521
7521
Plus / N N/B MAINTENANCE
Plus / N N/B MAINTENANCE
8.8 HARD DRIVE TEST ERROR
Either an error message is shown , or the driver motor continues spinning ,
while reading data is from or writing data is to hard drive.
while reading data is from or writing data is to hard drive.
HARD DRIVE TEST ERROR.
Replace mother BD
or into board-level
Troubleshooting.
or into board-level
Troubleshooting.
Board-level
Troubleshooting for
hard drive test error.
Check the following parts for cold solder or one of the following
parts on the mother-board may be defective, use an oscilloscope
to check the following signal or replace the parts one at a time and
test after each replacement.
parts on the mother-board may be defective, use an oscilloscope
to check the following signal or replace the parts one at a time and
test after each replacement.
Re-boot
OK?
Correct it
then end.
then end.
YES
NO
Check if HDD’s cable installed to
HDD and system properly (J516)
HDD and system properly (J516)
Re-boot
OK?
Replace the
faulty parts
then end.
faulty parts
then end.
YES
NO
1. Try another known good HDD.
2. Try another known good HDD’s
2. Try another known good HDD’s
Transulation cable.
Parts:
U24, Q24
Q25, R210
RP46, RP47
RP45, RP58
R191, R211
R212, JS10
C253, C250
J516
Q25, R210
RP46, RP47
RP45, RP58
R191, R211
R212, JS10
C253, C250
J516
Signals:
PDD[0~15]
PDDACK#
PDIOR#
PDIOW#
PDDREQ
PDCS[1,3]#
PDA[0:2]
PIDEACTS#
PIDE_ PU
PDDACK#
PDIOR#
PDIOW#
PDDREQ
PDCS[1,3]#
PDA[0:2]
PIDEACTS#
PIDE_ PU
RDDP[0~15]
RPDDACK#
RPDIOR#
RPDIOW#
RCS[1,3]P#
RDAP[0~2]
RPDDACK#
RPDIOR#
RPDIOW#
RCS[1,3]P#
RDAP[0~2]