Hughes AN6-098P Manuale Utente

 

Tables 2 and 3 list the small hardware parts included in the 
antenna kits for the two radio types (J-type and cradle-type). 

The parts listed in Table 2 are included in both kits, for both radio 
assembly types. 

Table 2:  Small hardware parts used in antenna kits for both radio types

For assembling the antenna

¼-20 × 1-3/8-inch thread-cutting screws

4

These parts are used for attaching the: 
•  Reflector
•  Feed rods
•  Feed support tube

The hardware for each task is specified in Chapter 3 
– Assembling the antenna.

¼-20 × 1-inch hex bolts

3

¼-20 × 2-inch hex bolt

1

¼-inch flat washers

8

¼-inch lock washers

4

¼-inch hex nuts

4

For mounting the radio assembly (both types)

0.9-inch inside diameter O-ring *

1

These parts are used for both radio assemblies, to:
•  Attach the feed horn
•  Mount the radio assembly

The hardware for each task is specified in: 
•  Chapter 4 – Installing a J-type radio assembly
•  Chapter 5 – Installing a cradle-type radio 

No. 6-32 × 0.5-inch socket-head cap screws *

7

No. 6 internal tooth lock washers *

7

Silicone grease capsule

1

5/16-18 × 2.25-inch carriage bolts

2

5/16-inch flat washers

4

5/16-inch lock washers

4

5/16-inch hex nuts

2

* In the antenna kit for the J-type radio, the waveguide transition is attached to the feed horn at the factory, so 
these parts are factory installed.