Hughes AN6-098P Manuale Utente

 

Follow these steps to install the Az/El and reflector bracket 
assembly onto the mast:

1. Before you install the Az/El and reflector bracket assembly 

onto the mast pipe, use a bubble level to make sure the mast is 
plumb. 
Check the mast at two perpendicular locations, as shown in 
Figure 14.   

2. Slide the canister of the Az/El and reflector bracket assembly 

down onto the mast.
Figure 15 shows the Az/El and reflector bracket assembly on 
the mast.   

Note:

The mast must be plumb. The antenna assembly 

cannot be adjusted to correct for a mast that is not plumb.

Figure 14:  Making sure the mast is plumb

T0172005

To make sure the mast is
plumb, check with the level
in two positions at right
angles to each other.

Level

Mast

2nd level
position

Mast

Bubble must be centered
between marks.

Bubble

level

Note:

The mast must have an outside diameter of 

2-

3  

⁄

8

 inches (2.375 inches).