HP Latex 260 61-in Japan Printer (Designjet L26500 61-in Japan Printer) Manuale Utente

5. Up

 key: To go up in a menu or option, or to increase a value.

6. OK

 key: To confirm an action while in a procedure or interaction. To enter in a submenu in the

menu. To select a value when given an option.

7. Down

 key: To go down in a menu or option, or to decrease a value.

8. Back

 key: To go to the previous step in a procedure or interaction. To go to the upper level, or

leave the option in the menu, or when given an option.

9. Cancel

 key: To cancel a procedure or interaction.

10. Reset

 key: To restart the printer (as if it were switched off and switched on again). You will need

an implement with a narrow tip to operate this key.

11. Move substrate

 key: To move the loaded substrate forwards or backwards. While the printer is

printing, it can be used to fine-tune the substrate advance on the fly.

To highlight an item in the front-panel display, press the 

Up

 or 

Down

 key until the item is highlighted.

To select an item in the front-panel display, first highlight it and then press the 

OK

 key.

When this guide shows a series of front-panel display items like this: Item1 > Item2 > Item3, it

means that you should select Item1, then select Item2, then select Item3.

Information about specific uses of the front panel can be found throughout this guide.

The Embedded Web Server is a Web server running inside the printer. You can use it to obtain printer

information, manage settings and presets, align printheads, upload new firmware and troubleshoot

problems. Service engineers can use it to retrieve internal information that helps to diagnose printer

problems.

You can access the Embedded Web Server remotely by using an ordinary Web browser running on

any computer. See 

.

The Embedded Web Server window displays three separate tabs. Buttons near the top of each page

provide access to online help and supplies reordering.

10

Chapter 1   Introduction

ENWW