HP Latex 260 61-in Japan Printer (Designjet L26500 61-in Japan Printer) Manuale Utente

The printer may be in any one of the following states; some of them require waiting.

●

Ready (cold): The printer is powered on but has not printed yet, and the heaters are not turned

on.

●

Preparing to print: The printer is warming up the heaters and preparing the printheads to

print. This takes 1 to 8 min.

●

●

●

●

●

Curing: This takes 1.5 to 5 min.

●

Finishing: The printer is cooling down and preparing for stand-by. This takes 0.5 to 5 min.

If jobs of the same print mode as the already-printed file are sent while the printer is Curing (if the

cutter is not enabled) or Finishing, the printer goes to Preparing to print.

To save time between prints, concatenate jobs with the same print mode (same number of passes) and

turn the cutter off to skip the Curing and Finishing states. You can also use nesting to print several

jobs in the same workflow.

Even if the cutter is on or successive jobs use different print modes, it is better to print them all together

without delays to minimize the time spent in Preparing to print.

The printer margins determine the area between the edges of your image and the edges of the

substrate.

The margins for a particular print job are selected in the RIP software; if the job exceeds the substrate

width, it will be clipped.

The front panel offers additional settings for the bottom margin: see 

.

These settings apply only to single prints when the cutter is not in use. The bottom margin is not applied

between several prints sent at the same time, nor during double-sided printing.

ENWW

Printer states

81