Go-Go Babyz Car Seat NMJ2 Manuale Utente

Step 1.  Lay seat face down and insert retainer bar in between seat-belt 
holder of car seat.

Step 2. Align the bottom tabs with the bottom of the car seat and lay the 
gogo Kidz plate on the back of the car seat.

Step 3. Insert the screws into the holes on the back of the plate and tighten. 
You may need to pull up on the bar while screwing.

The gogo Kidz needs no special instructions when transporting the Britax® 

seat from place to place. However, when transporting a child over 35 lbs., 

strapped in the seat, follow these instructions:

Step 3.  Always secure your child with the safety harness provided by the car 
seat manufacturer. 

Step 1. Attach the gogo Kidz to the Britax car seat by following the assembly 
instructions. After the gogo Kidz is attached to the Britax seat, and the 
handle is in the collapsed position, pull 10 inches of the “versa-tether” 
strap from the pouch that is located on the rear of the seat near the top.

Step 2. Pull the strap over the handle and tighten the “versa-tether” by 
pulling on the end of the tether strap. Place excess strap back into the pouch. 
Tuck in all remaining latch and tether straps in order not to get tangled when 
in use.

Please follow the instructions above for complete assembly.

To attach the Wizard/Boulevard Retainer Bar, 
roll the cut out portion around the bar in the 
back of the seat, starting from the bottom with 
the cut out prtion facing the top of the seat. 
The two conical sections should be facing 
towards you at this point. Use the fingers of 
one hand to align the conical shapes with the 
holes int he main plate and thred the Thumb-
screws with the other hand.