Edelbrock 91147 Dépliant

Catalog #91147
Rev. 4/08 - AJ/mc

©2008 Edelbrock Corporation

Brochure #63-91147

PLEASE study these instructions carefully before beginning this installation. If you have any questions, please call our Technical Hotline at:
1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday or e-mail us at Edelbrock@Edelbrock.com.

DESCRIPTION: This is a USB to Serial communications adapter cable. It is used to convert a
Laptop or PC USB port to a 9-pin RS232 serial communications connector. This item is included
in all QwikData Data Acquisition and Edelbrock EFI kits. Software drivers are included on the
supplied CD.

❑ 1 USB-to-Serial Adapter Cable

Hardware – A USB-enabled PC or Laptop

Software – Microsoft® Windows 98SE/ME/2000/XP

INSTALLATION: The drivers for the USB-Serial Port adapter cable are located on the supplied CD.

Insert the disc into your CD-ROM drive and click on 

“Install USB-to-DB9” then follow the onscreen prompts.

NOTE: You may use the same program to un-install the driver if desired. Run the “PL-2303 Driver Installer” program again and
follow the prompts to un-install the driver.

TROUBLESHOOTING: If the adapter is not communicating after installation of the driver, follow the troubleshooting suggestions below.

•

Many serial devices will not operate on a COM port higher than 4. If the COM port is higher than 4, change it to a lower number using the Device
Properties.

•

To change the assigned COM number, go to the Start menu, click Control Panel then System. Select the Hardware tab and then Device Manager.
Select the category 

“Ports (COM & LPT)” and right click the device “USB-to-Serial (COM x)” (Or a similar name. “X” represents the assigned COM

number). Click the Port Settings tab, then the Advanced button. A box will be in the lower left corner to assign a different COM port to the adapter.

NOTE: This procedure applies only to Windows 98SE, ME, 2000, and XP.