DTS RV4700 DTS-ES Manuale Utente

2

Congratulations on Your Purchase!
Your new high fidelity receiver is designed to deliver
maximum enjoyment and years of trouble free service.
Please take a few moments to read this manual thoroughly. It
will explain the features and operation of your unit and help
ensure a trouble free installation. Please unpack your unit
carefully. We recommend that you save the carton and
packing material. They will be helpful if you ever need to
move your unit and may be required if you ever need to
return it for service. Your unit is designed to be placed in a
horizontal position and it is important to allow at least two
inches of space behind your unit for adequate ventilation and
cabling convenience.
To avoid damage, never place the unit near radiators, in front
of heating vents, in direct sunlight, or in excessively humid or
dusty locations. Connect your complementary components
as illustrated in the following section.

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol is intended to alert the user to the 
presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.

This symbol is intended to alert the user to the 
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.

To reduce the risk of fire or electric shock, do not expose this
appliance to rain or moisture.

Note to CATV System Installer: This reminder is

provided to call the CATV system installer's attention to
Article 820-40 of the NEC that provides guidelines for
proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.

This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician

for help.

CAUTION : Any changes or modifications in construction
of this device which are not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.

UNPACKING AND INSTALLATION

To maintain proper ventilation, be sure to
leave a space around the unit (from the
largest outer dimensions including projections)
equal to, or greater than, shown below.

Left and right panels: 5 cm
Rear panel: 10 cm
Top panel: 20 cm