Wayne-Dalton 8850 Manuale Utente

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your 

local yellow pages/business listings or go to the 

Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

Tools Needed:

� 

� 

(4) 1/4”- 20 X 7/8” SELf 

DRILLING SCREWS

1/8”

Power Drill

7/16” Socket 

Driver

Tape Measure

NO. 6 SCREW EYE

PULL ROPE

BOTTOM BRACKET

PULL ROPE

Install the side lock on the second section 

of the door. Secure the lock to the section 

with (4) 1/4”- 20 x 7/8” self drilling 

screws. Square the lock assembly with 

the door section and align with the square 

hole in the vertical track. The side lock 

should be spaced in approximately 1/8” 

from the section edge.

imPoRTaNT: SIDE LOCKS MUST BE 

REMOVED OR MADE INOPERATIVE IN ThE 

UNLOCKED POSITION If AN OPERATOR IS 

INSTALLED ON ThE DOOR.

NoTe: After completing this step, continue 

with step 9 on page 13.

1/8”

DO NOT INSTALL PULL ROPES 

ON DOORS WITh ELECTRIC 

OPERATORS. ChILDREN MAY 

BECOME ENTANGLED IN ThE 

ROPE CAUSING SEVERE OR fATAL 

INjURY.

Measure and mark the jamb 

approximately 48” to 50” (1220 to 1270 

mm) from floor on the right or left side of 

door. Drill 1/8” pilot hole for No. 6 screw 

eye. Install the No. 6 screw eye. Tie the 

pull rope to the No. 6 screw eye and to 

the bottom bracket as shown.

Power Drill 

1/8” Drill Bit