Yamaha SP2060 V1 Manuale Proprietario
Panel Operation
SP2060 Owner’s Manual
Fore
w
o
rd
Netw
ork Settings
Ref
erences
P
anel Operation
Intr
oduction
to the SP2060
The Contr
ols
and Connector
s
26
ROUTING
Input routing
You can select either analog or digital input signals. This se-
lection links to the word clock master setting. You can also
route the left channel of an input signal received at the [IN-
PUT A] or [DIGITAL IN] connector to both Input chan-
nels A and B.
lection links to the word clock master setting. You can also
route the left channel of an input signal received at the [IN-
PUT A] or [DIGITAL IN] connector to both Input chan-
nels A and B.
1.
Press the [ROUTING] key to select the
Routing display.
Routing display.
2.
Press the [
▲INC]/[▼DEC] keys to select an
input signal source.
Output routing
You can route Input channel A, B, and SUM signals to the
Crossover input.
Crossover input.
The following three channels are available:
•
IN A
•
IN SUM
•
IN B
1.
Press the [ROUTING] key to select the
Routing display.
Routing display.
2.
Press the [SEL] key for the target Output
channel.
channel.
The [SEL] key LED for the selected channel lights up.
The [SEL] key LED for each channel that shares the
same component flashes. The selected channel name ap-
pears on the display.
The [SEL] key LED for each channel that shares the
same component flashes. The selected channel name ap-
pears on the display.
3.
Press the [
▲INC]/[▼DEC] keys to select an
input source to be routed to the Crossover.
Option
Input Signal Selection
Word Clock
Master
Master
ANA A/B
A signal at the [INPUT A]
connector is routed to
channel A, and a signal at
the [INPUT B] connector
to channel B.
connector is routed to
channel A, and a signal at
the [INPUT B] connector
to channel B.
Internal clock:
96kHz
96kHz
ANA A/A
A signal at the [INPUT A]
connector is routed to
channels A and B.
connector is routed to
channels A and B.
DIG L/R
A left channel signal is
routed to channel A, and
a right channel signal to
channel B.
routed to channel A, and
a right channel signal to
channel B.
Incoming AES/
EBU signal
EBU signal
DIG L/L
A left channel signal is
routed to channels A and
B.
routed to channels A and
B.
HINT
You can check the word clock status on the Utility display. See
page 34.
page 34.
NOTE
Signals are muted while they are switched between analog and
digital to avoid noise.
digital to avoid noise.
INPUT SELECT
SOURCE = ANA A/B
SOURCE = ANA A/B
INPUT SELECT
SOURCE = ANA A/A
SOURCE = ANA A/A
OUT 2
SOURCE = IN A
SOURCE = IN A
OUT 4
SOURCE = IN A
SOURCE = IN A
OUT 4
SOURCE = IN SUM
SOURCE = IN SUM