Vector Travelmate VEC002 Dépliant

•  Intended for indoor use only

.

•  Do not expose to rain, moisture or sunlight.

•  Do not block ventilation slots.

•

Do not attempt to open outer casing. Electrical hazard may result.

•

Only use to operate 12-volt devices that are equipped with a power cord rated at a

minimum of No. 18 A

WG copper

.

• 

 Do not insert fingers into the converter's 12 volt receptacle

.

•  Keep children away from converter while it is operating.

•  Do not insert cigarette lighter into converter’

s socket.

•  The 12 volt socket is wired so the center conductor is Plus (+) and the shell

conductor is Negative (-). Make sure the 12 volt appliance plug is wired correctly

.

Congratulations on your selection of the V

ector AC/DC adapter

. It is useful for

a wide variety of applications including: Operating and charging cell phones,

automotive accessories that require less than 4 Amps of 12 V

olt current.  This

includes 12 V

olt operated Thermoelectric Coolers/W

armers, Spotlights to 50

watt bulb rating, Portable Air Ionizers, and 

Charging Jumpstarters. The VEC002

is UL listed and is tested to USA (UL) and Canadian Safety Standards (cUL).

•

Connect converter's power cord to 110/120 V

olt AC outlet.

•

Insert 12 V

olt appliance plug into the converter’

s socket.

•

Remove 12 V

olt plug from converter

.

•

Disconnect converter's power cord from 110/120 V

olt ac outlet.

•

Allow converter to cool for at least 30 minutes before storing.

12 V
olt plug not making good connection in socket, rotate 12 V

olt

plug in socket.

With power disconnected, clean socket and reinsert plug.

Check AC outlet by plugging in another appli

ance. 

If 

outlet 

has

no power

, check fuses, circuit breakers and wall switches to

restore power

.

See fuse replacement.

•

Disconnect AC and appliance from from converter

.

•

Place your unit on a stable flat surface.

•

Remove screws from unit's cover

, then remove cover

.

•

Follow wiring from input plug to rubber "boot" that

 covers in-line

 fuse.

•

Carefully remove rubber boot, then remove fuse from fuse holder

.

•

Remove fuse.  If it is discolored or if its internal wire is broken, replace

with identical type and amper age rating (2 Amp gma).

•  Replace fuse and rubber "boot".

•  Replace cover and screws without over

-tightening.

•

Connect AC to converter and plug in appliance. T

est the appliance for

proper operation. If there is a problem with the converter

, call V

ector

Technical Supportat 954-584-4446, Extension 119.

•

Do not immerse converter in water

.

•  

Wipe outside surface of the converter with a damp cloth. The

use of

any other material may cause permanent damage and will void the

warranty

.