VIZIO MACH 1 VZL-6011 Manuale Utente
www.vax.co.uk
10
general maintenance
8. General maintenance
WARNING: to reduce risk of injury from moving
parts - unplug before servicing.
parts - unplug before servicing.
Debris removal/hose
Debris removal/nozzle guard
• Check to see if dirt container is full; empty if needed.
• Plug cleaner in and check to see if there is any suction
at end of hose. If there is no suction at the end of hose,
follow these steps:
follow these steps:
1. Unwrap hose from caddy. Twist and unlock to remove
clogs. Clean out hose with a broom handle. Check access
door on back of cleaner (near hose end). Remove the
seven (7) screws and check for obstruction (Fig.8/1).
clogs. Clean out hose with a broom handle. Check access
door on back of cleaner (near hose end). Remove the
seven (7) screws and check for obstruction (Fig.8/1).
2. Remove dirt container (Pg. 6) and check dirt container
inlet located on cleaner (Fig.8/1).
inlet located on cleaner (Fig.8/1).
3. Remove nozzle guard (see Fig.8/2) by removing the
three (3) screws. Remove obstructions (Refer to Page 8
for belt and brushbar removal and replacement).
three (3) screws. Remove obstructions (Refer to Page 8
for belt and brushbar removal and replacement).
9. Troubleshooting
WARNING: TO REDUCE RISK OF PERSONAL INJURY,
UNPLUG VACUUM CLEANER BEFORE SERVICING
UNPLUG VACUUM CLEANER BEFORE SERVICING
PROBLEM: Cleaner won’t run
Cause:
Not properly plugged into wall outlet.
Solution:
Plug in firmly.
Cause:
No electricity in wall outlet.
Solution:
Check fuse or breaker.
Cause:
On/off switch not turned on.
Solution:
Push on/off switch to on.
Cause:
Motor thermostat tripped.
Solution:
Switch off and unplug the vacuum cleaner.
Leave for one (1) hour. See page 3.
Leave for one (1) hour. See page 3.
Cause:
Blown fuse/tripped breaker.
Solution:
Reset circuit breaker or replace fuse.
PROBLEM: Cleaner won't pick up
Cause:
Full or clogged dirt container.
Solution:
Clean dirt container.
Cause:
Clogged nozzle.
Solution:
Remove obstruction.
Cause:
Clogged dirt inlet.
Solution:
Remove suction channel cover and remove
obstruction.
obstruction.
Cause:
Clogged hose.
Solution:
Remove obstruction.
Cause:
Hose not inserted fully.
Solution:
Push hose in securely.
Cause:
Dirty filters or filter container.
Solution:
Clean/change filters or filter container.
PROBLEM: Accessories won't pick up
Cause:
Accessories not attached correctly.
Solution:
Refer to page 5 for fitting information.
PROBLEM: Brushbar does not turn
Cause:
Brushbar blocked.
Solution:
Remove blockages.
PROBLEM: Air flow restricted with attachment use
Cause:
Attachment use restricts air flow.
Solution:
Check attachment.
Cause:
New carpet debris clogging air path.
Solution:
Remove obstruction.
Fig.8/1
Fig.8/2
!
!
Vax VZL-6011 User Guide.qxd:VZL-6011 User Guide 17/9/08 11:03 Page 10