Z-Com XG-762N Manuale Utente
5
3. Getting Start
3.1 Load the driver
Generally, the driver is automatically loaded when the XG-762N dongle inserts. If not,
one can use the modprobe ¨C
one can use the modprobe ¨C
v XG-762N to load our driver. In order to check whether our
driver is loaded successfully, one can use the ¡°
lsmod¡±
f or t hi s check. If our dri ver i s
loaded successfully, the following messages should be seen
...
XG-762N 183576 0 (unused)
...
Please note that the 183576 may not be the same as that in your system.
...
XG-762N 183576 0 (unused)
...
Please note that the 183576 may not be the same as that in your system.
3.2 Open the network interface
In our driver, we will stop all the commands until the network interface assigned to us is
opened. You can open the network interface by the following command
]$ ifconfig ethX up
or
]$ ifconfig ethX <IP address>
opened. You can open the network interface by the following command
]$ ifconfig ethX up
or
]$ ifconfig ethX <IP address>
3.3 Configure the Wireless settings
In our driver, we support the wireless extension commands to control our driver.
PARAMETERS:
essid :
essid :
Set the ESSID (or Network Name - in some products it may also called Domain
ID). The ESSID is used to identify cells which are part of the same virtual
network.
network.
Examples:
mode:
Set the operation mode of our device.
Examples:
mode:
Managed (Infrastructure Station mode)
Ah-hoc (Ad hoc mode)
Master (Access Point mode)
Ah-hoc (Ad hoc mode)
Master (Access Point mode)
channel:
Set the channel in the device.
iwconfig ethX <mode>
iwconfig ethX essid <ESSID>