Peugeot ELYSEO 125 Manuale Utente
Removing and refitting
the wheels
Important
For your safety, PEUGEOT recommends that you :
For these operations we advise you to contact a
garage equipped with special tooling or a Peugeot
dealer (agent).
For these operations we advise you to contact a
garage equipped with special tooling or a Peugeot
dealer (agent).
- When dismantling, be careful not to damage the pipework,
brake disc, brake pads and brake shoes
- Check the location of the parts, washers and exhaust seal in
order to put them back in the right place
- Do not action the front brake lever once the wheel has been
removed as the calliper pistons may cause a leakage of brake fluid.
In the event of this happening, see a dealer who will carry out the
operation.
In the event of this happening, see a dealer who will carry out the
operation.
- Removing front wheel
- Position the vehicle on its central stand, place a support
under the vehicle in such a way that the wheel is free and the
vehicle is stable.
vehicle is stable.
- Block the wheel axle
- Loosen and remove the nut and remove the washer
- Loosen the screw
- Push the wheel axle using a rubber hammer if necessary
- Remove the wheel
- Loosen and remove the nut and remove the washer
- Loosen the screw
- Push the wheel axle using a rubber hammer if necessary
- Remove the wheel
- Refitting front wheel
- Position the reduction gear on the wheel
- Line up the wheel between the fork tubes and position the
- Line up the wheel between the fork tubes and position the
reduction gear on the tube
- Introduce the wheel axle
- Put the washer in place and tighten a new nut to a
- Put the washer in place and tighten a new nut to a
tightness torque of 5 m.daN whilst blocking the axle
- Tighten screw to 1.2 m.daN
- Removing rear wheel
- Release the rear brake
- Loosen the two screws
- Free the screws and and remove them whilst
- Loosen the two screws
- Free the screws and and remove them whilst
holding the exhaust pipe (be careful of the weight and risk of burning)
- Loosen the RH shock absorber support screw and pivot it
upwards
- Loosen the suspension arm support screw and remove it
- Loosen the central wheel bolt
- Loosen the central wheel bolt
- Refitting rear wheel
- Retighten the central wheel bolt to a torque of
10 m.daN
- Put the suspension arm back in place and retighten it
- Retighten the rear shock absorber screw to a torque of
- Retighten the rear shock absorber screw to a torque of
2.5 m.daN
- Put the exhaust pipe and seal in place, start the screw start
the screw and then refit the exhaust seal carefully then tighten
screws and
screws and
- Check the good adjustment of the brake
4
3
5
6
A
4
3
5
4
3
6
16
5
9
7
8
12
10
11
8
7
11
9
8
9
12
10
12
7
10
8
A
4