NEC 0612-20 Manuale Utente

1

3

4

6

5

3.  Hold  tools by insulated gripping sur-

faces when performing an operation 
where the cutting tool may contact 
hidden wiring or its own cord. Con-
tact with a “live” wire will make exposed 
metal parts of the tool “live” and shock 
the operator.

4.  Keep hands away from all cutting 

3/8"

1/2"

7/8"

1"

1"

1-1/8"

1-1/4"

1-3/4"

1/4" 

1/4"

7/8"

1-1/4"

3/8"

1/2"

12

14.4

Low 0 - 400

High 0 - 1400

Low 0 - 400

High 0 - 1400

Direct Current

No Load Revolutions 
per Minute (RPM)

Underwriters 
Laboratories, Inc., 
United States and 
Canada

2

1.   Speed selector

2. Tool 

holder

3.   Trigger

4.   Control switch

5.   Keyless chuck

6.   Torque selector collar

Battery pack can be inserted onto the tool 
in two ways.

1.  For working in restricted spaces, insert 

the battery pack from the front by sliding 
battery pack onto the body of the tool. 
Insert the battery pack until the battery 
latches lock. 

2. 

For optimum weight distribution and bal-
ance,  insert the battery pack from the 
back by sliding the battery pack onto the 
body of the tool. Insert the battery pack 
until the battery latches lock.

3. To 

remove the battery pack, press in 

both battery latches and slide the battery 
pack off of the tool.

The Clip-Lok system consists of three pieces; 
the belt clip, the tool holder, and the bit 
holder. The system is shipped assembled for 
right-handed use. To change the assembly 
for left-handed use:

1.   Remove battery pack.

2.   Remove screws holding the tool holder 

and the bit holder. 

3.  Lift the holders at  the narrow end and 

pull the front tangs out of their slots.

4.  Replace the pieces onto the desired 

side by sliding the tangs into the slots. 
Tighten the screws securely.

The belt clip can be mounted to tool belts, 
bags, buckets, etc. To mount the belt clip:

1.  Pull up the clamp release. The clamp 

will pop out.

2.  Slide the clamp over the tool belt, bag, 

bucket, etc.

3.  Press in the clamp to tighten.

1. To attach the tool to the belt clip, slide 

the tool holder over the stud on the belt 
clip until it is held in place by the protrud-
ing pin.

2. To 

release the tool from the belt clip, 

grasp the tool handle, push down on 
the tool release lever with your thumb, 
and pull up on the tool.

The bit holder holds two standard 1/4" hex 
shank bits up to two inches long.

1.  Insert the bit by pressing it into the clip.

2.   Remove the bit by lifting the tip of the 

bit and pulling it out of the clip.

Tool release lever

Stud

Pin

Clamp

Clamp 

release 

Front tangs