NewAir AW-121E Manuale Utente

z 

Remove exterior and interior packing material. 

z 

Check to make sure the following parts are included: 

‹ 

3 slide-out shelves 

‹ 

Door handle and 2 screws 

‹ 

Instruction manual 

z 

Before connecting the appliance to the power supply, let it stand upright for 

approximately 2 hours. This will reduce the possibility of malfunction in the cooling 

system that may have occurred from handling during transportation. 

z 

Clean the wine cooler’s interior surface with lukewarm water using a soft cloth 

before using the wine cooler for the first time. 

 

z 

Place the appliance on a floor that is strong enough to support it when it is fully 

loaded.    To level the wine refrigerator, adjust the front feet located on the bottom of 

the appliance.

 

z 

Keep the wine cooler away from direct sunlight and excess heat sources such as 

stoves, heaters, radiators, etc.    Direct sunlight may affect the unit’s acrylic coating 

and heat sources may increase electricity consumption.    Extreme cold or hot 

ambient temperatures may also cause the appliance to perform improperly. 

z 

This unit can be recessed.    Please allow a 1” inch clearance all around the unit.     

 

 

 

 

Do not store food items in the wine refrigerator.    The unit’s interior temperature may not 

be low enough to prevent spoilage. 

 

It is recommended that you keep the wine refrigerator in a place where the ambient 

temperature is between 77-80.6° F. If the ambient temperature is above or below the 

recommended temperature range, the unit’s performance may be affected.    Using the 

wine refrigerator in extreme cold or hot conditions may cause interior temperatures to 

fluctuate, and the ideal range of 54-66° F may not be reached. 

 

The temperature display reflects the temperature of the area near the center racks in the 

wine refrigerator. Keep in mind that the temperature may fluctuate approximate +/-7 

degrees on the top or bottom racks.     

 

The temperature may fluctuate depending on whether or not the interior light is on or off 

and whether the bottles are located on the upper, middle, or lower racks.     

 

Use the push buttons to set your desired temperature.    Use the “▲” and “▼” to adjust the 

temperature by 1° F between 54-66° F. You can turn the interior light on or off by pressing 

the “light” button.