KUHN RIKON Kuhn Rikon Corp. Saw 10" WOODWORKING BANDSAW Manuale Utente

Keep your proper footing and balance at all times.

Serious injury could occur if the tool is tipped or if the cutting tool is accidentally contacted.

Before initial or continual use of the tool, a guard or other part that is damaged should be checked to assure that
it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other
damaged parts should immediately be properly repaired or replaced.

Always Disconnect Tools.

Disconnect tools before servicing and when changing accessories such as blades, bits, and cutters.

Make sure switch is in “OFF” position before plugging in cord.

 

1.  Always stop the Bandsaw before removing scrap pieces from table.

 2.  Always keep hands and fingers away from the blade.

 3.  Never attempt to saw stock that does not have a flat surface, unless a suitable support is used.

 4.  Always hold material firmly and feed it into the blade at a moderate speed.

 5.  Always turn off the machine if the material is to be backed out of an uncompleted cut.

 6.  Adjust the upper guide about 1/8” to 1/4” above the material being cut.

 7.  Check for proper blade size and type for thickness and type of material being cut.

 8.  Make sure that the blade tension and blade tracking are properly adjusted.

 9.  Make “relief” cuts before cutting long curves.

10.  Release blade tension when the saw will not be used for a long period of time.

4