Cuno AP717 Dépliant

Aqua-Pure® Ice Maker Ice Filters come complete with 
all the necessary hardware.  All you need is a tube cutter, 
a wrench and a knife.  Simply follow the easy step-by-step
instructions inside the box to connect the Aqua-Pure
Ice Maker Water Filter to your refrigerator’s incoming cold 
water line.

You can also count on your Aqua-Pure filter to eliminate
the problem of ice maker clogging and corrosion, and extend 
the life of your equipment.  And each filter gives you up to six 
months of great tasting water.  After 6 months, just replace the 
filter.  So start enjoying tastier beverages today.

• Do not install on line pressure above 125psi (862kPa).
• Do not use wicking or pipe dope sealer for fitting 

connections into head of filter. Teflon® tape is 
recommended. 

• Protect from freezing. Drain filter when room temperature 

drops below 32°F (0°C)

• Do not use with water that is microbiologically unsafe or of 

unknown quality without adequate disinfection before or 
after the system.

• Do not install in direct sunlight.
• Installation must comply with existing state or local 

plumbing codes.

Read all instructions carefully before installing your filter.

For use on 1/4” copper or plastic tubing.

1. Shut-off your refrigerator’s water source.

2. Locate an easily 

accessible section 
of tubing. Shut-off 
valve must be on 
inlet side of filter.

3. Cut and remove a 6” 

(152.4 mm) section of    
tubing making sure ends 
are cut square.

4. Unscrew nuts from filter 

fittings and slip ferrules   
and nuts over tubing ends.
If your tubing is plastic, 
install the supplied plastic 
inserts into ends of tube.

AP717
WATER FILTER