Autostart CT-5060 Manuale Utente

 

CT-5060 User Guide 

P. 10 

•  Entering Cold Weather Mode 

•  Exit Ready Mode 

•  Enter Remote Valet 

•  Enter ignition valet 

•  +12 volts detected on the Brake line; cranking cancelled 

•  Entering Tach Learning 

•  New Transmitter learnt  

•  Tach learnt 

•  Remote start attempt was made with a Tach or a vacuum signal 

detected before cranking 

•  Unit reset: occurs when the unit is reset to factory defaults 

•  The Hood Switch line went to ground during cranking or run time 

•  There was an attempt to start the vehicle while the Module was in 

Valet Mode. 

•  There was an attempt to start the vehicle while the Module was in 

Home Valet Mode. 

•  Cold Weather Mode: the Brake Pedal is being held down 

•  The Hood is up and the Hood Switch line went to ground. This is 

step one of the Programming Mode 

•  First press of the 

START/STOP 

button under Safe Start. 

•  Entering Home Valet Mode 

• 

LOCK 

or 

 pulse (if door pulse is configured to 4 sec.) 

• 

If the Hood Pin-switch has been pressed twice: the Unit went into 
step 1 of the Programming cycle and no Transmitter activity was 

detected for 20 seconds 

•  Or  the Unit went into step 1 of the Transmitter Code Learning 

procedure and no activity was detected for a few seconds. The 

Unit has exited the Transmitter Code Learning procedure. 

•  If the Module gives irregular flashes (1 to 10 flashes followed by a 

pause, followed by more flashes), it is in Playback Mode. This 
occurs when the Hood-switch line is flashed 3 times. 

•  Panic Mode set off.