American Dynamics KT-PC4204 Dépliant
Tel.: 1 (450) 444 2030
• Toll Free: 1 888 222-1560 • Fax: 1 (450) 444 2029 • Internet: www.kantech.com
DN1246-0404
Copyright
2004 Kantech Systems. All rights reserved • Specifications may change without notice.
Kantech Systems
KT-PC4204
4 Relay Output and Power Supply
1. Introduction
The KT-PC4204 is an output module with four programmable relays and can be
used to repower the Combus (see KT-300 installation manual in the Combus
Repower Section). This module is also used for elevator control.
Note: Do not use any power supply other than the KT-PC4204 to repower the
Note: Do not use any power supply other than the KT-PC4204 to repower the
Combus. If a power supply other than the KT-PC4204 is used, the Combus
repower function will not operate as intended.
2. Specifications
•
Current Draw: 30 mA (from Combus)
•
16VAC/40VA transformer required
•
Maximum 7Ah battery required
•
Connects to the controller via 4-wire Combus
•
Four programmable relay contacts rated 2A, 30VDC
•
AUX current: 1.0A max.
•
Tamper contact input
•
Can be used to repower the combus
•
Can be used for elevator control
3.
Installing the KT-PC4204
3.1. Unpacking
The KT-PC4204 package should include the following parts/items:
•
•
One (1) KT-PC4204 circuit board
•
One (1) ground wire assembly
•
Five (5) plastic standoffs
•
One (1) 5A replacement fuse
•
One (1) installation instructions sheet
3.2. Mounting
The KT-PC4204 should be located inside a compatible cabinet (Kantech part no.
KT-4051CAB), mounted in a dry and secure location. Preferably, it should be
placed at a convenient distance from the connected devices.
Perform the following steps to mount the unit:
1.
1.
Press the five (5) plastic standoffs through the mounting holes at back of the
cabinet,
2.
Secure the cabinet to the wall in the desired location. Use appropriate wall
anchors when securing the cabinet to drywall, plaster, concrete, brick or
other surfaces,
3.
Press the circuit board into the plastic standoffs to secure the module to the
cabinet.
Once the unit is mounted, wiring may be started.
3.3. Installation and Wiring
Before beginning to wire the unit, ensure that all power (AC transformer and
battery) is disconnected from the KT-300 controller.
Perform the following steps to complete wiring:
1.
Perform the following steps to complete wiring:
1.
Connect the four Combus wires to the KT-PC4204. Connect the red, black,
yellow and green Combus wires to the RED, BLK, YEL and GRN
terminals, respectively.
If the module is being used for Combus Repower, connect the Combus wires
according to the following diagram. For this option, Jumper J1 must also be
set for “Combus Relay.”
2.
Complete all output wiring,
3.
Connect the external tamper switch, if used.
Consult the above wiring diagrams for further information.