ADC ISDN NT11010 Manuale Utente
10
Wiring instructions
Figure 4 shows the wiring diagram of the 1010 with the ISDN Customer Premise
Equipment (CPE) and the Line Termination (LT). Follow the instructions given
below to set up the 1010:
Equipment (CPE) and the Line Termination (LT). Follow the instructions given
below to set up the 1010:
Figure 4—Wiring diagram
1
Adjust the DIP switches for the desired S/T wiring setup (see Table 4).
2
Connect the DC power plug of the AD62010 to the power connector on the
side of the 1010.
side of the 1010.
3
Plug the AD62010 into the AC power outlet. The POWER LED will light
and the S/T&U LED will light or flash depending on the line status.
and the S/T&U LED will light or flash depending on the line status.
4
Connect one end of the RJ45 cable into the U-interface connector on the
1010. The other end goes into the U-interface wall outlet.
1010. The other end goes into the U-interface wall outlet.
5
Switch on the power to the ISDN terminal equipment. Connect one end of
the RJ45 cable provided, to one of the S/T connectors on the 1010, and
connect the other end to the ISDN TE.
the RJ45 cable provided, to one of the S/T connectors on the 1010, and
connect the other end to the ISDN TE.
6
If a second ISDN TE will be used, repeat step 5 to connect the second ter-
minal to the second S/T connector.
minal to the second S/T connector.
7
The S/T&U LED may begin to flash for a few seconds. The LED will go
off when the communication paths have linked. When the LED goes off,
the ISDN CPE is ready for communication.
off when the communication paths have linked. When the LED goes off,
the ISDN CPE is ready for communication.