Apogee 2020 Manuale Utente
ETHCX1
INTERFACE CONTROLLER MODULE
APOGEE LABS, Inc.
AL4300 Series
5.25.04
2020-3
2020.1.3 FEATURES
• Standard single slot AL4300 module
• Slot-independent operation
• Automatically replaces existing remote control
• Complies with 10/100 base-T Ethernet operation
• Fully supports Apogee Labs standard full duplex remote control protocol
• Switch-enabled automatic reset of default IP address setting
• Slot-independent operation
• Automatically replaces existing remote control
• Complies with 10/100 base-T Ethernet operation
• Fully supports Apogee Labs standard full duplex remote control protocol
• Switch-enabled automatic reset of default IP address setting
2020.1.4 SPECIFICATIONS
• Compliant with IEEE 802.3 / Ethernet V.2
• 10/100 Base-T operation
• RJ-45 connector
• Full Duplex Operation
• Supports TCP/IP, UDP and Apogee Labs NNAT
• Occupies one AL4300 chassis slot
• 10/100 Base-T operation
• RJ-45 connector
• Full Duplex Operation
• Supports TCP/IP, UDP and Apogee Labs NNAT
• Occupies one AL4300 chassis slot
2020.2
INSTALLATION
2020.2.1 MODULE PLACEMENT
CONSIDERATIONS
The ETHCX1 plug-in module may be placed anywhere within the AL4300 series chassis. The
front panel processor, which interrogates the backplane to determine the presence of modules
upon the initial application of power to the unit, recognizes this module as the default remote
control device.
front panel processor, which interrogates the backplane to determine the presence of modules
upon the initial application of power to the unit, recognizes this module as the default remote
control device.
2020.2.2 CABLES
The following figure illustrates the only connection to be made:
Figure 2 - ETHCX1 Front and Side Panel Views