Digi MIL-120A Manuale Utente

 

Install Guide

Model: MIL-120A

2

 

Do the following to install the MIL-120A:

1. Attach a UTP cable from the network to the MIL-120A's RJ-45 port

2. Attach a T-type BNC connector from the network cabling to the BNC 

connector

3. Connect the power adapter's cord from the power source to the unit

 

Use shielded twisted pair (CAT 5) cabling for CISPR 22 B installation.

 

The MIL-120A provides a 

 

 test function, which is a 10BASE-T standard. The 

MIL-120A ships with the 

 

 function test “enabled”—only pin one jumpered 

with a jumper block. This allows the LEDs to illuminate when there are links.

 

To disable the 

 

 test:

1. Use a Phillips-head screwdriver to remove the four Phillips-type screws 

located on the sides of the unit

2. Remove the BNC nut and its washer

3. Slide the housing off, over the BNC connector

4. Locate the two-pin 

 

 jumper (Figure 1)

5. Place the jumper block onto both pins

6. Reassemble the unit (reverse steps 1 through 3)

 

The MIL-120A operates in a “StarLAN-10” environment when 

 

Link

 

 is disabled. Only the 

 

 and 

 

 LEDs Illuminate.

Link Test 
Enabled

1   2

DIP Switch