Digi MIL-170TRM Manuale Utente
Install Guide
Model: MIL-170TRM
3
M D I - X / M D I S w i t ch
The MDI-X/MDI switch allows for quick configuration of the 10BASE-T port.
Cables used when the switch is in the MDI-X position (the “left” position):
Cables used when the switch is in the MDI-X position (the “left” position):
• For a hub/repeater, use a swap cable (pins are connected 1 to 3, 2 to 6, 3 to 1,
and 6 to 2)
• For a workstation/PC, use a straight-through cable (pins are connected 1 to 1,
2 to 2, 3 to 3, and 6 to 6)
Figure 1.Inside of the MIL-170TRM
Cables used when the switch is in the MDI position (the “right” position):
• For a hub/repeater, use a straight-through cable (pins are connected 1 to 1, 2 to
2, 3 to 3, and 6 to 6)
• For a workstation/PC port, use a swap cable (pins are connected 1 to 3, 2 to 6,
3 to 1, and 6 to 2)
L i n k S e n t r y C o n fi g u r a t i o n
The Link Sentry feature on the MIL-170TRM is configured through a 4-position
DIP switch (refer to Figure 1). Default setting for the DIP switches: All switches
are in the “up” position.
DIP switch (refer to Figure 1). Default setting for the DIP switches: All switches
are in the “up” position.
Link Sentry allows users to add new management tools to the network. When
enabled, it monitors the selected receiver port and, if the Link test signal is not
seen, the unit will stop sending a signal through the selected transmit port.
enabled, it monitors the selected receiver port and, if the Link test signal is not
seen, the unit will stop sending a signal through the selected transmit port.
MDI-X/MDI
Switch
RJ-45 Female
Connector
ST-Type
Connectors
4
3
2
1
3
2
1
LEDs
(4 total)
4-pin DIP Switch