Bose AM272394 Manuale Utente
4
Preparing for Use
English
Installing remote control batteries
1.
On the back of the remote, slide open the
battery compartment (Figure 1).
battery compartment (Figure 1).
2.
Insert the two supplied AA (IEC-R6) 1.5V
batteries, or their equivalent, as shown.
Match the plus (+) and minus (–) marked on
the batteries with the plus (+) and minus (–)
inside the battery compartment.
batteries, or their equivalent, as shown.
Match the plus (+) and minus (–) marked on
the batteries with the plus (+) and minus (–)
inside the battery compartment.
3.
Slide the battery compartment cover back
into place.
into place.
Note:
Replace the batteries when the remote
control stops operating or its range seems
reduced.
reduced.
Figure 1
Installing the batteries
Programming the advanced remote
Find the four-digit setup code for your cable box,
satellite box, or TV in the Appendix at the end of
this guide.
satellite box, or TV in the Appendix at the end of
this guide.
–
+
+
–
There may be more than one code listed for
your model of a particular product brand.
If you notice a lack of response or limited
functionality after programming the remote,
you may need to use a different code for
that product.
If you notice a lack of response or limited
functionality after programming the remote,
you may need to use a different code for
that product.
Note:
When the remote is programmed
for use with both the cable/satellite box and
the TV, the channel controls on the remote
will change channels on the cable/satellite
box and not on the TV
the TV, the channel controls on the remote
will change channels on the cable/satellite
box and not on the TV
.
AM272394_00_pdf • October, 2003