LXE Home Security System E-EB-VX6UG-E Manuale Utente

 

 

 

 

For proper and safe installation, the input power cable must be connected to a fused 

circuit on the vehicle. This fused circuit requires a 10 Amp maximum time delay (slow 

blow) high interrupting rating fuse. If the supply connection is made directly to the 

battery, the fuse should be installed in the positive lead within 5 inches of the battery 

positive (+) terminal.

 

 

 

For installation by trained service personnel only.

 

 

 

Risk of ignition or explosion. Explosive gas mixture may be vented from battery. 

Work only in well ventilated area. Avoid creating arcs and sparks at battery terminals.

 

Note:  Please see “Power Adapter Cable” later in this section for information on adapting a 

VX1, VX2 or VX4 DC power supply to the VX6. 

Note:  Correct electrical polarity is required for safe and proper installation. Connecting the 

cable to the VX6 with the polarity reversed will cause the VX6’s fuse to be blown. See 

the following figure titled “Vehicle Connection Wiring Color Codes” for additional wire 

color-coding specifics. 

1. 

The VX6 must be turned off and the power cable must be UNPLUGGED from the VX6. 

2. 

While observing the fuse requirements specified above, connect the power cable as close 
as possible to the actual battery terminals of the vehicle. When available, always connect 
to unswitched terminals in vehicle fuse panel, after providing proper fusing.