Lund Industries MW520 Dépliant

 

 

 
 

MW-520 Keyboard and Display Mount 

 

 
 
1. 

Bolt the MW-520 Keyboard and Display mount to console adapter bracket using the 
supplied 1/4” hardware.   Adjust tension on swivel assembly by tightening or loosening 1/4” 
swivel bolts.  

 
2. 

Screw flat monitor screen to the top section of mount using factory supplied screws 

 and 

washers. 

sides   when opening and closing. 
 
3. 

Connect the display cable to the monitor screen.  When connecting cable to the CPU  

             be careful to allow enough slack to operate the Tilt/Swivel without straining the cable. 
 
4. 

Mount keyboard by sliding unit backward onto mount tabs and the downwards over 

 

spring clip.  Or if locking clip is used tighten screws until keyboard is secure. 

 
5. 

Use the side handle to adjust tension or “Lock” the monitor.  DO NOT OVER 

 TIGHTEN - The monitor should not be so tight that it can’t move up or down with 
 reasonable 

force. 

 
6. 

The mount can be swiveled by grasping the keyboard plate and moving from side 

 

to side.  Tilt adjustment is a knurled knob under the right side of the keyboard plate.  

 

Loosen the knob and position the mount,  then tighten the knob to lock the mount in 

 position.  
 

 

C A U T I O N 

 
 
When driving, the monitor should be down to keep it out of the airbag zone.  If left up the monitor 
should be close to the dashboard and NOT in the airbag deployment zone.  Note: Most vehicles 
have an area just off the center of the  

deployment zone. 
 
Replacement bushing kits (P/N # 520-NY-W2) are available for the side handle knob.  Tightening 
the knob without nylon washers in place will cause excessive wear on the bearing assembly.