LevelOne WBR-3460 Manuale Utente

Setup 

 

15 

If the Wireless ADSL2/2+ Modem Router does not respond, check the 
following: 
•  The Wireless ADSL2/2+ Modem Router is properly installed, LAN 

connection is OK, and it is powered ON. You can test the connection by 
using the "Ping" command: 
•  Open the MS-DOS window or command prompt window. 
•  Enter the command: 

   ping 192.168.0.1 
If no response is received, either the connection is not working, or 
your PC's IP address is not compatible with the Wireless ADSL2/2+ 
Modem Router's IP Address. (See next item.) 

•  If your PC is using a fixed IP Address, its IP Address must be within the 

range 192.168.0.2 to 192.168.0.254 to be compatible with the Wireless 
ADSL2/2+ Modem Router's default IP Address of 192.168.0.1. Also, the 
Network Mask must be set to 255.255.255.0. See Chapter 4 - PC Con-
figuration for details on checking your PC's TCP/IP settings. 

•  Ensure that your PC and the Wireless ADSL2/2+ Modem Router are on 

the same network segment. (If you don't have a router, this must be the 
case.)  

•  Ensure you are using the wired LAN interface. The Wireless interface 

can only be used if its configuration matches your PC's wireless set-
tings. 

 

The first time you connect to the Wireless ADSL2/2+ Modem Router, you should run 
the Setup Wizard to configure the ADSL and Internet Connection. 

1. Click 

the 

Setup Wizard link on the main menu 

2.  On the first screen, select VC 1 (Router - Primary Internet Connection), then click 

"Next"