Land Pride Car Video System 4220ST Dépliant
2
Manual No. 701-170M
12/05/06
Land Pride
Assembly Instructions
■
Head Rest Assembly
Figure 1
24822
Kit No. 701-169A
HEAD REST WITH MOUNTING POST KIT
Item Qty.
Part No.
Part Description
1
2
700-420H
HEAD REST MOUNTING POST
2
8
700-500d
JOINT PLATE
3
4
802-152C
HHCS 1/4-20X2 GR5
4
4
802-738C
HHCS 5/16-18 X 1 GR5
5
4
803-255C
NUT HEX NYLOCK 1/4-20
6
8
804-007C
WASHER FLAT 1/4 SAE PLT
7
2
804-036C
WASHER FLAT 5/16 SAE PLT
8
2
840-179C
HEAD REST WITH MOUNTING HARDWARE #4 & #7
1
701-170M
MANUAL, HEAD REST WITH MOUNTING POST
Head Rest Assembly
Refer to Figure 1:
1.
1.
Behind the driver, attach bottom joint halves (#2) to
the 4-Post Accessory Bar lower cross member with
1/4"-20 x 2" GR5 hex head cap screw (#3), 2- flat
washers (#6) and nylock hex nut (#5). Do not tighten
nylock nuts.
the 4-Post Accessory Bar lower cross member with
1/4"-20 x 2" GR5 hex head cap screw (#3), 2- flat
washers (#6) and nylock hex nut (#5). Do not tighten
nylock nuts.
2.
Attach top joint halves (#2) to the 4-Post Accessory
Bar upper cross member with 1/4"-20 x 2" GR5 hex
head cap screws (#3), 2- flat washers (#6) and
nylock hex nuts (#5). Do not tighten nylock nuts.
Bar upper cross member with 1/4"-20 x 2" GR5 hex
head cap screws (#3), 2- flat washers (#6) and
nylock hex nuts (#5). Do not tighten nylock nuts.
3.
Insert head rest mounting post (#1) into the bottom
joint halves and then into the top joint halves.
joint halves and then into the top joint halves.
4.
Adjust joint halves to center the head rest behind the
driver’s head and tighten nylock nuts to 8 ft-lbs.
driver’s head and tighten nylock nuts to 8 ft-lbs.
5.
Locate a desirable height that will protect the driver’s
head using two of the six holes in the head rest
mounting post (#1).
head using two of the six holes in the head rest
mounting post (#1).
6.
Attach head rests (#8) to the mounting post at that
height with 5/16"-18 x 1" GR5 hex cap screws (#4)
and flat washers (#7) as shown.
height with 5/16"-18 x 1" GR5 hex cap screws (#4)
and flat washers (#7) as shown.
7.
Tighten cap screws to 11 ft-lbs.
8.
Repeat steps 1 through 7 for the passenger side.