Viking RVMH330SS Istruzione Sull'Installazione

4

7  Preparation of the Oven

Separate mounting plate from oven by removing two 
screws. See illustration below. Save these screws for use 
in section Mounting Oven to Wall, figure /.

Mounting 

Plate

Back of Microwave

figur

e

figur

e

4

8  Ventilation System

  

(Preparing Oven for Installation)

This Built-in Microwave Hood is designed for adaptation 
to three types of hood ventilation systems. Select the 
type required for your installation.

rEcirculating — non-vented, ductless.  

 

Follow installation procedure (A). Recirculating requires 
the use of the Charcoal Filter, which has already been 
installed in the oven.

hOrizOntal Exhaust — outside ventilation.  
Follow installation procedure (B).

VErtical Exhaust — outside ventilation.    
Follow installation procedure (C).

(A) Recirculating:

 Non-Vented, Ductless 

Operation

•  The unit is shipped assembled for recirculating. 
•  The Exhaust Damper Assembly 

7

 is NOT REqUIRED 

for recirculating operation.

(B) Horizontal Exhaust:

 Outside 

Ventilation

figur

e

figur

e

5

1) HORIZONTAL EXHAUST:  Remove 2 screws from back 

edge and 3 screws from the top center of Fan Cover Bracket. 

Save 2 screws to be used later and discard remaining 3. 

Remove Fan Cover Bracket by sliding it in the opposite 

direction of the arrow on the Fan Cover Bracket.

figur

e

figur

e

6

Hood Fan Unit

2) HORIZONTAL EXHAUST: Lift Hood Fan Unit carefully 

and slip wires out of cavity.  

 

 

• cautiOn: Do not pull or stretch hood fan wiring.

figur

e

figur

e

7

(A) Rotate 180˚

(B)

3) HORIZONTAL EXHAUST:  Rotate the Hood Fan Unit 

180˚ so that the fan blade openings are facing the back of 

the oven. See figure 7 (A). Replace Hood Fan Unit into the 

oven. Be careful not to pinch the wire and the Hood Fan 

Unit. See figure 7 (B).