Dacor DH3606S Istruzione Sull'Installazione
7
Installation Instructions
Suggested
electrical
location
Hood
location
Electrical Service Installation
Install a junction box in the vicinity of the hood electrical
access holes according to local codes. Install it above the
hood. The diagram below shows the suggested location.
Drill a 7/8” hole in the ceiling or cabinet as necessary to
Drill a 7/8” hole in the ceiling or cabinet as necessary to
allow the wiring to pass through into the hood. See page
3 for hole locations.
Duct Cutout
1. Using a pencil, draw the vertical center line for the
range hood on the surface above the hood mounting
location. The center line for the hood is usually halfway
between the cabinets at the installation location or the
same as the center line of the cooktop or range.
2. Draw a line perpendicular to the range center line
drawn in step 1. Draw it 6 1/8” (15.6 cm) out from the
wall.
3. Cut a hole above the mounting location in the ceiling or
cabinet for the duct to pass through. It must be 8 1/2”
(22 cm) in diameter and centered on the lines drawn in
steps 1 and 2.
Ceiling or cabinet
bottom above
installation location
CL
6 1/8”
(15.6 cm)
8 1/2”
(15.6 cm)
dia. duct
hole