Bosch NETP066SUC Manuale

20

This appliance requires no maintenance other than daily 

cleaning. For best results, apply cooktop cleaning cream 

daily.

If you encounter a problem, it often will merely be 

something minor. Before you call customer service, 

consider the suggestions and instructions below:

9

Repairs should only be done by a trained servicer.
Improper repair of your appliance may result in risk 

of severe physical injury or death.

Pans with aluminum, copper or stainless steel bases may 

leave marks. Treat immediately after surface has cooled 

with glass ceramic cooktop cleaner. If this does not 

remove the marks, try a mild abrasive (Bon Ami®, Soft 

Scrub® without bleach) with a damp paper towel. Rinse 

and reapply glass ceramic cooktop cleaner. Failure to 

remove metal marks before the next heating makes 

removal very difficult.

Hard water spots:
Hot cooking liquids dripped on surface

Minerals in some water can be transferred onto the sur-

face and cause stains. Use undiluted white vinegar, rinse 

and dry. Recondition with glass ceramic cooktop cleaner. 

Remove boilovers and stains before using the cooktop 

again.

Surface scratches:
Small scratches are common and do not affect cooking. 

They become smoother and less noticeable with daily use 

of the glass ceramic cooktop cleaner. 

Apply glass ceramic cooktop cleaner before using to 

remove sand-like grains and grit such as salt and sea-

soning. Scratches can be reduced by using pans with 

bases that are smooth, clean, and dry before use. Use 

recommended glass ceramic cooktop cleaner daily.
NOTICE: Diamond rings may scratch the surface.

Cooktop is not working The electric power supply has been 

interrupted.

Use other electrical appliances to check if there has 

been a power outage. Check to see if there is a prob-

lem with the circuit breaker for the electrical installa-

tion.

The appliance has not been cor-

rectly connected following the con-

nection diagram.

Make sure that the appliance has been connected cor-

rectly.

Electronic system malfunction.

Contact the Technical Assistance Service.

“

 is flashing on the ele-

ment display

The touch control zone is wet, very 

dirty, food has boiled over, or an 

object is lying on top of the touch 

control zone.

Clean the touch control zone, or remove the object. 

Lightly touch the corresponding touch key. The flash-

ing should stop.

“

 flashes on all ele-

ment displays. An 

accoustic signal 

sounds

The main switch has been activated 

continuously for more than 5 sec-

onds.

Press the power key again. Reset the cooktop.

The cooktop turns off 

by itself

The main switch has been touched 

unintentionally.

Press the main switch again. Reset the cooktop.