Dacor RNR30NC Utilizzo E Cura

Pagina di 36
25
Optional Cookie Sheets
Clean the optional aluminum cookie sheets with a solu-
tion of detergent and warm water. Since aluminum can 
scratch, you need to use the soft side of a sponge. A way 
for you to keep cookie sheets cleaner is to use parchment 
paper over the cooking surface during baking. The parch-
ment paper will also prevent food from sticking.
Optional Baking Stone
Wash the optional baking stone with hot water and scrub 
it clean before you use it for the first time. Do not use any 
soap or detergents to wash the it. The stone is porous and 
soap will get trapped inside. The trapped soap will affect 
the flavor of the food cooked on it. Do not be alarmed 
if the stone gets stains on it after it is used for a while. 
Stains do not affect the stone’s ability to bake properly.
When you need to remove large food particles from the 
baking stone, use warm water and a scrub brush. If there 
is a lot of oil build-up, it may smoke and create odors. If 
you need to remove the oily build up, use a scouring pad 
or brush to remove it. You may also use a paste of baking 
soda and water to scrub off small stains.
Replacing the Light Bulb(s)
 WARNING
•  To prevent electrical shock and/or personal injury, 
make certain that the oven and light bulb are cool 
and that power to the range has been turned off 
at the circuit breaker panel or fuse box before 
replacing the light bulb.
•  Always make sure the lens cover is in place when 
using the oven. The lens cover protects the bulb 
from breakage.
•  Replacing the lens cover without lining up the cutout 
with the light socket will damage the light fixture.
•  Do not use a screwdriver to remove the lens.
•  Light bulb replacement is considered a homeowner 
maintenance operation. If the light does not work, 
before replacing it, please consult the Problem Solu-
tion Guide on page 26.
•  Replace the light bulb only with Dacor part number 
107112. See page 28 for ordering information. 
 IMPORTANT
Do not touch the replacement halogen light bulb with 
your fingers. Halogen bulbs are sensitive to the oils 
from your hand. The oils from your hand will stick to the 
bulb and may cause it to burn out faster than normal.
Care and Cleaning
To replace a light bulb, follow these steps:
1.  Turn off power to the range at the circuit breaker 
panel or fuse box.
2.  Hold your hand under the lens for support and gently 
pry it loose using a spatula or table knife. Pull the lens 
cover straight out.
3.  Grasp the old bulb and pull it straight out of the 
socket.
4.  Using a glove, insert the new bulb into the socket. 
5.  As you reinstall the lens cover, line up the cutout on 
the inside rim with the light socket. Gently press it 
into its original position.
6.  Turn the power to the range back on. Reset the clock 
(see page 9).
Light fixture 
in oven wall
Light  
socket
Lens
Lens 
cutout
Light bulb